ProTee Vertical Launch Camera
Update your older ProTee system to the latest spec.
ProTee Vertical Launch Camera Update your Point Grey Cameras
ProTee Vertical Launch Camera will capture the ball flight in mid air and uses the captured launch angle in the simulation software.
Captures Vertical Ball Launch Angle
Floor Mounting Bracket
USB Extension Cable 5 meter / 16 feet
The ProTee Base Sensor System and 2nd overhead light is required.
ProTee Vertical Launch Camera setup instructions
Step by step instructions on how to setup your ProTee Golf Simulator Vertical Launch camera.
IMPORTANT: REQUIRES PROTEE GOLF INTERFACE VERSION 3.14 OR HIGHER
1] Connect the vertical launch camera to your computer
Make sure at least 1 camera is connected to your computer before you install the driver software.
2] Download and run the latest camera driver software
Download link: Camera Drivers
When the driver installation process is finished, the cameras will show up in the Windows device manager under Imaging devices as “The Imaging Source Europe GmbH DMK …”.
3] Position the Vertical Launch Camera
The camera is positioned correctly approx 7′ from the ball on the left or right side of your setup
Check camera is levelled horizontally
The camera is pointing / turned slightly towards your screen
4] Start the ProTee Golf Interface
Goto Settings -> More
Enable the Vertical Camera and click Save
Click on V Cam to open the Vertical Camera Setup Screen
Select the Camera you want to assign as Vertical Camera from the Camera listbox
Click on Preview
ProTee cameras shipped after October 15, 2017 will appear in the list as DMK cameras.
5] Line up the camera
Place a golf ball on the white rubber tee position
Position the camera so the ball is inside the red box of the Preview image
Position the camera so the red line on the bottom is hortizontal with the floor
Make sure the the hitting direction is towards the screen. The impact screen can appear just inside the camera view on the right side. You can filter this out with the Right exclusion slider
6] Adjusting light
- Make sure your everything outside the simulator is dark
- Dim any ambient light and cover windows
- Click on Camera devices
- Use the Gain slider to adjust the light levels